Netconfig doesn't detect Vertex controllers

Owned by Mateusz Borycki (Unlicensed)
Last updated: Feb 08, 2024 by Jakub Cupiał
1 min read

If you can’t see any controllers in the netconfig, it may be because of several factors. Read this troubleshooting article and find your solution.

Before you start

Try the proposed solutions in The most common errors. Check if netconfig does not detect one or more VERTEX control units.

Solution 1

  1. Type in the http://YOUR_VERTEX_IP/netconfig in the browser.

  2. Follow the steps described here. Check if all controllers are seen within the netconfig.

  3. Make sure that all controllers are assigned with the intended IP addresses. Then, commission the system accordingly to E2D Commissioning.

Solution 2

If you have done the network configuration before and then you don’t see Vertexes in the netconfig, check if Vertexes have been properly assigned with network settings. In your browser type: http://YOUR_VERTEX_IP:1880/vertex/neghbours

If the file is empty or unavailable to reach, contact us to get further support.