Glamox Ethernet2DALI Knowledge Base
What do you want to know?
This documentation applies to the E2D system using Vertex 3 with software version 3.1.30 or higher, or Vertex 4. If you have Vertex 2 or 3 with software versions up to 3.1.29, go to https://glamox.atlassian.net/wiki/x/iQC-Yw
PDF for download → Apr 24, 2026
Design
Components
- LMS E2D VERTEX APC G4 (V4)
- E2D Sensors
- Wireless Bluetooth sensor + bridge + kinetic switch
- Panel: LMS DALI-2 SWITCH PANEL
- Panel: LMS DALI-2 SM CROSS NFC WH
- LMS E2D DALI-2 6xINPUT MODULE
- Relays
- Toltec CV
- LMS E2D TOUCH PANEL 8"
- V-TOUCH S
- LMS E2D REMOTE ACCESS KIT
- LMS E2D SH SWITCH 5-PORT DIN
- Suitable luminaires for E2D
Commissioning
- Commissioning request
- Good practices before commissioning
- 1. Setting up the network
- 2. E2D User interface - opening instructions and overview
- 3. Vertex software updating
- 4. Clearing devices on the buses
- 5. Identifying luminaires
- 6. Grouping of luminaires
- 7. Control devices
- Network requirements
- Manual reboot of the Vertex
- Creating lighting scenes
- Commissioning report
- Emergency setup
- System backup - creating
- System backup - restoring
- Password Change
- Device List
Programming logic (Node-Red)
Components Commissioning
- Sensor Commissioning
- Sensor LMS DALI-2 PIR CLS SENSOR-R LONG commissioning
- Control panel buttons - general
- LMS DALI-2 SWITCH PANEL commissioning
- LMS DALI-2 SM CROSS NFC WH commissioning
- LMS E2D DALI-2 6xINPUT MODULE commissioning
- Relay commissioning
- Phase dimmer commissioning
- LMS E2D TOUCH PANEL 8" commissioning
- LMS E2D TOUCH PANEL software release notes