/
Measurement of the DALI bus current

Measurement of the DALI bus current

under construction

Vertex 3 provides information if the current on the DALI bus will be over 230 mA. This functionality will ensure that DALI current limits are met.

 Instructions

 

  1. Log in to the Vertex GUI.

  2. In the System Status section, you will see a warning monit when the current on any bus will be exceeded (see photo below)

  3. Make sure that the devices on the DALI bus don’t consume more than 230 mA.

Warning about the exceeded DALI current.

 

This monit will appear only when you will excess the allowed 230 mA. Real-time measurement of the DALI current should be performed using electrical instrumentation.

 

Related content

Time synchronization
Time synchronization
Read with this
(Classic) Measurement of the DALI bus current
(Classic) Measurement of the DALI bus current
More like this
VERTEX 3 Modern
VERTEX 3 Modern
Read with this
(Classic) 0. Good practices before commissioning
(Classic) 0. Good practices before commissioning
More like this
6. Grouping of luminaires
6. Grouping of luminaires
Read with this
Good practices before commissioning
Good practices before commissioning
More like this