/
(Classic) Measurement of the DALI bus current
This documentation applies to the E2D system using VERTEX 2 & 3 with CLASSIC UI and software versions up to 3.1.29. If you have VERTEX 3 with software version 3.1.30 or higher, go to Glamox Ethernet2DALI |
---|
(Classic) Measurement of the DALI bus current
Vertex 3 provides information if the current on the DALI bus will be over 230 mA. This functionality will ensure that DALI current limits are met.
Instructions
Log in to the Vertex GUI.
In the System Status section, you will see a warning monit when the current on any bus will be exceeded (see photo below)
Make sure that the devices on the DALI bus don’t consume more than 230 mA.
Warning about the exceeded DALI current.
This monit will appear only when you will excess the allowed 230 mA. Real-time measurement of the DALI current should be performed using electrical instrumentation.
Related content
(Classic) DALI design - limits
(Classic) DALI design - limits
More like this
(Classic) Network requirements
(Classic) Network requirements
Read with this
Measurement of the DALI bus current
Measurement of the DALI bus current
More like this
(Classic) How to remove a single luminaire?
(Classic) How to remove a single luminaire?
Read with this
(Classic) 0. Good practices before commissioning
(Classic) 0. Good practices before commissioning
More like this
(Classic) Troubleshooting
(Classic) Troubleshooting
Read with this