Glamox Ethernet2DALI Knowledge Base
What do you want to know?
This Knowledge Base applies to the E2D system using Vertex 3 and Vertex 4, with software version 5.1.1 or higher.
Have an older device or software version? Go to https://glamox.atlassian.net/wiki/x/B4Cy_/
PDF for download → Jun 15, 2026
Design
Components
- LMS E2D VERTEX APC G4 (V4)
- E2D Sensors
- Wireless Bluetooth sensor + bridge + kinetic switch
- Panel: LMS DALI-2 SWITCH PANEL
- Panel: LMS DALI-2 SM CROSS NFC WH
- LMS E2D DALI-2 6xINPUT MODULE
- Relays
- Toltec CV
- LMS E2D TOUCH PANEL 8"
- V-TOUCH S
- LMS E2D REMOTE ACCESS KIT
- LMS E2D SH SWITCH 5-PORT DIN
- Suitable luminaires for E2D
Commissioning
- Good practices before commissioning
- 1. Connecting to the Vertex
- 2. Logging in to the UI
- 3. Network configuration (NetConfig)
- 4. Vertex software updating
- 5. Clearing devices on the buses
- 6. Identifying luminaires
- 7. Grouping of luminaires
- 8. Control devices
- Network requirements
- Manual reboot of the Vertex
- Creating lighting scenes
- Commissioning report
- Emergency setup
- System backup - creating
- System backup - restoring
- Device List
- User management
Programming logic (Node-Red)
Components Commissioning
- Sensor Commissioning
- Sensor LMS DALI-2 PIR CLS SENSOR-R LONG commissioning
- Control panel buttons - general
- LMS DALI-2 SWITCH PANEL commissioning
- LMS DALI-2 SM CROSS NFC WH commissioning
- LMS E2D DALI-2 6xINPUT MODULE commissioning
- Relay commissioning
- Phase dimmer commissioning
- LMS E2D TOUCH PANEL 8" commissioning
- LMS E2D TOUCH PANEL software release notes