/
(Classic) Vertex factory reset

This documentation applies to the E2D system using VERTEX 2 & 3 with CLASSIC UI and software versions up to 3.1.29. If you have VERTEX 3 with software version 3.1.30 or higher, go to Glamox Ethernet2DALI

(Classic) Vertex factory reset

Owned by Katarzyna Stodolny
Last updated: Apr 03, 2023
1 min read

A factory reset restores the factory settings on the Vertex. Do this directly from the front panel of the Vertex.

A factory reset will permanently remove the existing addressing, grouping and logic.

Instructions

  1. Press the Power button in the following sequence:

    press (5 seconds), release (1 second), press (5 seconds), release (1 second), press (5 seconds), release

2. The Status LED will start to flash red. Vertex will now reboot and restore the factory settings. This may take some time (up to several minutes).

Related content