7. Linking

Presence

Presence linking allows actication of other lumianires when a sensor in a specific lumainire detects presence. You can create individual or multiple links.

Create individual links

  1. Select Luminaires [1] and Link [2].

image-20240118-153008.png
  1. Determine the two fittings to be linked and drag your finger between the two devices.

  2. If you require a bi-directional link, draw a line back the other way.

If you draw an individual link line, the luminaire will not Link to Self and it's PIR will not become active. Select Link to Self [3] on the individual luminaire to enable this.


Create multiple links

  1. Select the group of luminaires you'd like to link by dragging your finger over them.

image-20240118-153127.png
  1. You will be presented with 6 options:

  • Link All(xx) - This will link all luminaires together so that presence detected on any sensor will turn the other linked fittings on.

  • Unlink All - This will remove all presence links for the group of devices.

  • Link From X - This will provide a link from another device. If you select this option you will be prompted to enter the full device serial ID.

  • Link To X - This will provide a link to another device. If you select this option you will be prompted to enter the full device number.

  • Link to Self – Link luminaires to themselves so they will operate independently.

  • Me & 8 - This will allow for smaller groups of fittings to be linked within a large group and is typically used in open areas. The '8' can be changed to a larger number with a long press on the 'Me & 8' button. To implement and alter Me & 8:

    • Highlight the whole group to be controlled in this way

    • Long press Me&8

    • A popup box will prompt you to enter the group size > save

    • Press the Me&xx button again (this will now display the number you entered)

    • A diagram will appear on the drawing

    • Confirm to apply or cancel to change

If you tap on a luminaire whilst in the Link tab you will see all current links to that device.

  1. Ensure all the fittings and links are blue and Synced - using the Sync button [4] in the top left.

If you make changes to links or which links a device has then you must check that all changes have been synced.


Daylight

The next step: Backup

Â