/
Switches / Input-unit

Switches / Input-unit

Owned by Katarzyna Stodolny
Last updated: Feb 14, 2025 by Knut Marius Fosse
3 min read

ZIGBEE GREENPOWER

The switch is designed for use with the Glamox Wireless Zigbee system. It allows manual control of the system and operates on a Zigbee GreenPower network. These switches are self-powered using kinetic technology, eliminating the need for batteries or external power sources.

The comfort of the usage is very high due to the low mechanical force needed for pressing the buttons. In addition to conventional ON/OFF control, you can use this button for dimming the light and triggering lighting scenes.

https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/b12202005/

https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/b12202002/

The switch requires an additional frame

https://www.glamox.com/en/pbs/products/indoor/downlight/1411701/

Ā 

INPUT UNIT

You can also use standard push buttons with our ZIGBEE INPUT UNIT (INPUT UNIT). The commissioning process is identical to that of ZIGBEE GREENPOWER.

How to use it in the LMS design

Limitations

  • See system limitations dictated by the sensor.

  • Add all luminaires in a group first and then add a switch. The switch binding mechanism is to each node within the Zigbee group at the time of commissioning. If new nodes are added after commissioning, switch binding does not take place.

  • A switch can be added either to a group or to a zone. Once added to a zone, another switch will need to follow the same choice i.e. either a group or a zone.

  • All switches attached within a group should belong to a single brand. Combining switches from different brands is not recommended.

  • In case switches are used for a group and at the same time for zones of that group, three things need to be taken into account:

    • The switch of the group should be added first.

    • Only 2-button switches should be used for the group.

    • In the zones, 4-button switches with scene settings can be used.

  • It is recommended to use not more than one 4-button switch per zone.

  • If two or more zones are used with a 4-button switch, the maximum number of lights is 20 per zone.

  • In case the switch is not detected during the commissioning procedure, please re-try.

  • The switch needs to be mounted so that ā€œIā€ is at the TOP and ā€œOā€ at the BOTTOM (check the picture).

  • It is only allowed to use switches / input units from one supplier in one group.

  • During the commissioning of ZGP switches (in test setups) the devices should not be too close to the lights (between 2m and 5m distance) to avoid commissioning failures.

How to commission it?

For commissioning a switch, follow the steps shown in the app.

Adding switches (panels)

Ā 

Related content