7. Linking
Presence
Presence linking allows actication of other lumianires when a sensor in a specific luminaire uses PIR or microwave. You can create individual or multiple links.
The limit on bidirectional linking on a single device is 36. However, unidirectional links can be created without any limitation.
Create individual links
Select Luminaires tab and make sure you are in the Locate section.
Determine the two fittings to be linked and drag your finger between the two devices.
If you require a bi-directional link, draw a line back the other way.
If you draw an individual link line, the luminaire will not Link to Self and it's PIR will not become active. Select Link to Self [3] on the individual luminaire to enable this.
Create multiple links
Select the group of luminaires you'd like to link by dragging your finger over them.
You will be presented with options:
Link selected - This will link all selected luminaires together so that presence is detected on any sensor will turn the other linked fittings on.
In this case we had 10 luminaires so the command was 
Unlink All - This will remove all presence links for the group of devices.
Link From X - This will provide a link from another device. If you select this option you will be prompted to enter the full device serial ID. This is used when you want to link from a device on a different drawing.
Enter device number and select finish to create link.
Link To X - This will provide a link to another device. If you select this option you will be prompted to enter the full device number. This is used when you want to link to a device on a different drawing.
Link to Self – Link luminaires to themselves so they will operate independently 
Me & 8 (dynamic grouping) - This will allow for smaller groups of fittings to be linked within a large group and is typically used in open areas. The '8' can be changed to a larger number with a long p
Long press
A popup box will prompt you to enter the group size > save
Press the Me&xx button again (this will now display the number you entered)
A diagram will appear on the drawing
Confirm to apply or cancel to change
Me and X links are created.
Daylight - to set up Daylight linking make sure the profile is set correctly.
After selecting lumianires you want to link click
Now choose the luminaire with Daylight functionality you want to send out commands.
Daylight links are created.
If you tap on a luminaire whilst in the Link tab you will see all current links to that device.
Ensure all the fittings and links are blue and Synced - using the Sync button in the top left.
If you make changes to links or which links a device has then you must check that all changes have been synced.