/
Manual reboot of the Vertex

Manual reboot of the Vertex

Instructions

  1. Log into the Vertex GUI as an administrator.

  2. Go to the Settings [1] section and then go to the Vertex cluster tab [2] . That’s where you will see the list of Vertex controllers within the cluster.

  3. Click on the Actions [3] drop down list

  4. Choose the Reboot button which you would like to reset. [4]

The controllers will then restart. This may take several minutes. After that, remember to check the status of the system.

 

Related content

Device List
Read with this
Vertex factory reset
Vertex factory reset
More like this
Sensor commissioning
Sensor commissioning
Read with this
(Classic) Vertex factory reset
(Classic) Vertex factory reset
More like this
Emergency setup
Emergency setup
Read with this
3. Vertex software updating
3. Vertex software updating
More like this