LMS E2D VERTEX APC G3
- Katarzyna Stodolny
- Joanna Kozakiewicz
- Mateusz Borycki (Unlicensed)
Vertex 3 is a DALI2 compatible application controller.
PN8100701
General controller information
This controller can be used as an independent system or as part of a larger connected system
Lighting control for DALI and DALI-2 compatible luminaires
Support for and DALI-2 input devices (e.g. sensors and panels)
3 DALI ports that support up to 64 devices (up to 192 devices per one Vertex controller)
Error detection signaled via LED indicators
A built-in online lighting control and programing app
Ability to connect to other controlers and systems through Ethernet
Create extensive, cross-controller logic
Simple ON/OFF control of the DALI ports using buttons on the front panel
Technical parameters
Protection class | II |
|---|---|
Ethernet port | 10/100 Mbit - RJ45 |
USB port | 2 x USB-A, USB 2.0 |
Short-circuit DALI bus current | 3 x 250 mA |
Continuous DALI bus currrent | 3 x 230 mA |
Power supply protection | 630 mA fuse |
All work on the DALI bus must be carried out with the power supply 230 V for the Vertex unit switched off.
VERTEX status LEDs
LED | Status | Description |
|---|---|---|
Power | ON | Device on |
OFF | Device off | |
Status | GREEN | Device ready to operate |
RED | Error with the device (see Troubleshooting) | |
OFF | Device startup sequence | |
Cloud | ON | Glamox Connect connection established |
BLINKING | Not connected to Glamox Connect | |
Ports | ON | DALI bus short circuit |
BLINKING* | DALI bus transmission | |
BLINKING** | AC power voltage on DALI bus |
*For each DALI frame

**1 Hz frequency
How to use it in the LMS design?
See the principles of E2D design and good practices.
How to commission it?
See the Commissioning section.
Â