This documentation is for older software versions (up to 3.1.29). If you have software version 3.1.30 or higher, go to MODERN Home |
|---|
(Classic) LMS E2D VERTEX APC G3
- Katarzyna Stodolny
- Joanna Kozakiewicz
Functions
Lighting control for DALI-2 compatible luminaires
Support for DALI-2 input devices (e.g. sensors and panels)
A completely autonomous controller
3 DALI ports that support up to 64 devices (up to 192 devices per one Vertex controller)
Error detection signaled via LED indicators
A built-in online lighting control app
The system can be scaled using a standard Ethernet interface
Creating an extensive, cross-controller logic
ON/OFF control over the DALI ports using buttons on the front panel
Technical parameters
Protection class | II |
|---|---|
Ethernet port | 10/100 Mbit - RJ45 |
USB port | 2 x USB-A, USB 2.0 |
Short-circuit DALI bus current | 3 x 250 mA |
Continuous DALI bus currrent | 3 x 230 mA |
Power supply protection | 630 mA fuse |
DALI bus protection
Both vertex 2 and vertex 3 have a built-in DALI current limitation. In the event of a short circuit, the contact current is limited to 160 mA (Vertex 2) and 240 mA (Vertex 3). The maximum voltage on the DALI bus is 19-20 V DC and it is in the safe voltages. In the event of a 230 V AC short-circuit to the DALI Vertex 2 and 3 bus it will show in the user's graphical interface. In addition, in the Vertex 3 fuse will burn, which is only replaceable by the production plant. During a 230 V AC short-circuit to the DALI bus, active devices (sensors and buttons) may be burned. All work on the DALI bus must be carried out with the power supply 230 V for the Vertex unit switched off.
VERTEX ApC status LEDs
LED | Status | Description |
|---|---|---|
Power | ON | Device on |
OFF | Device off | |
Status | GREEN | Device ready to operate |
RED | Error with the device (see Troubleshooting) | |
OFF | Device startup sequence | |
Cloud | ON | Glamox connect connection established |
BLINKING | Not connected to Glamox Connect | |
DALI | ON | DALI bus short circuit |
BLINKING* | DALI bus transmission | |
BLINKING** | AC power voltage on DALI bus |
*For each DALI frame
**1 Hz frequency
How to use it in the LMS design?
See the principles of E2D design and good practices.
How to commission it?
See the Commissioning section.
For more information, search the Ethernet2DALI Knowledge Base.