/
4. Clearing devices on the buses
4. Clearing devices on the buses
If you are in the process of an initial setup make sure that you've completed the previous step: Vertex software updating.
By clearing the devices on the buses you will ensure that all the devices are properly read and addressed. It’s important you know it’s a hard reset of all devices.
Instructions
Choose Setting section [1]
Go to Vertex cluster [2] and log into the Vertex as an administrator.
Click on the Actions [3] drop down list
Choose the DALI bus you’d like to reset. [4]
Clearing devices may take about 30 seconds. After this operation, the Vertex controller finds the devices connected to the DALI port again and assigns new addresses to them. This may take several minutes.
The next step: 5. Identifying luminaires
, multiple selections available,
Related content
1. Setting up the network
1. Setting up the network
Read with this
System backup - restoring
System backup - restoring
More like this
2. E2D User interface - opening instructions and overview
2. E2D User interface - opening instructions and overview
Read with this
3. Vertex software updating
3. Vertex software updating
Read with this
Good practices before commissioning
Good practices before commissioning
Read with this
VERTEX 3 Modern
VERTEX 3 Modern
Read with this