Restoring factory settings - Maintenance mode
- Julian Słowiński (Unlicensed)
In some cases, for instance when a cell phone is lost, components cannot be removed via the standard method. In that situation, components can be factory restored via the Maintenence mode.
Procedure is done by turning ON and OFF luminaire’s power supply according to instruction/video below.
Instruction
The luminaires must be powered ON for more than 15 seconds.
Power OFF mains for more than 10 seconds but less than 15 seconds (disconnect device form mains)
Power ON mains for 2 to 3 seconds (reconnect device to mains)
Repeat above process for 4 times
On the 5th cycle, leave the fixtures powered ON at the end. You should see a short dim-down/dim-up signal. Sensors are now in Maintenance mode.
Scan with “Device Maintenance” to discover the sensors and reset them, see screenshots below:
Video tutorial with the ON/OFF cycles (5th cycle remain ON):