This documentation is for older software versions (up to 3.1.29). If you have software version 3.1.30 or higher, go to MODERN Home

(Classic) Customization of group parameter

Owned by Katarzyna Stodolny
Mar 31, 2023
2 min read

Actions that you can perform on a given group:

  • Identification - the luminaire will start to blink on site and this will allow its successful identification.

  • Stop Identification - this stops the luminaire identification action.

  • Remove luminaire - this manually removes the luminaire from the system, it will no longer be monitored by the Vertex controller.

  • Swap luminaire - this makes it possible to swap luminaires if the equipment was changed on-site and the old luminaire has been detected with the No communication error in the GUI.

  • Change properties - this makes it possible to configure and set individual parameters for luminaires or DALI-2 devices like fade rate, fade time, Power on level, Application controller mode, and others.

  • Set brightness level - this sets a chosen brightness level for a given luminaire/group.

How to work on groups

  1. Go to the Devices/Groups section and select the Settings tab.

2. Under the Settings tab, select:

  • Groups, if you want to manage groups,

  • All devices, if you want to manage individual devices,

  • Vertex/Port, if you want to manage the whole Vertex controller or a single DALI port.

3. You will see the list of all groups. Select one or multiple checkboxes.

4. Select the action you want to perform on the action panel.