/
(Classic) 5. Rebooting the Vertex

This documentation applies to the E2D system using VERTEX 2 & 3 with CLASSIC UI and software versions up to 3.1.29. If you have VERTEX 3 with software version 3.1.30 or higher, go to Glamox Ethernet2DALI

(Classic) 5. Rebooting the Vertex

Make sure that you've completed the previous step: Clearing devices on the buses.

Reboot the Vertex to be sure that all DALI devices are correctly connected and properly searched.

Instructions

  1. Log into the Vertex GUI as an administrator.

  2. Go to the Settings section and then go to the System details. That’s where you will see the list of Vertex controllers within the cluster.

  3. Select the Vertex you want to reboot. You can also reboot all Vertex controllers in the cluster by clicking Reboot all.

4. Vertex controllers will then restart. This may take several minutes. After that, remember to check the status of the system.

The next step: Identifying luminaires

 

Related content

(Classic) 4. Clearing devices on the buses
(Classic) 4. Clearing devices on the buses
More like this
(Classic) 2. How to get into Vertex GUI?
(Classic) 2. How to get into Vertex GUI?
Read with this
4. Clearing devices on the buses
4. Clearing devices on the buses
More like this
(Classic) 3. Vertex software updating
(Classic) 3. Vertex software updating
Read with this
(Classic) Checking a DALI installation
(Classic) Checking a DALI installation
More like this
(Classic) 1. Setting up the network
(Classic) 1. Setting up the network
Read with this