LMS E2D 6xINPUT MODULE
- Katarzyna Stodolny
- Joanna Kozakiewicz
- Mateusz Borycki (Unlicensed)
This input module allows you use standard potential free switches or pushbuttons from any manufacturer. The interface is equipped with 6 potential-free inputs. This allows for the connection of any normally open contacts to the lighting system. Apart from buttons: relays, time switches, presence/motion sensors, reed switches, etc. can be used.
How to use it in LMS design?
Example: Connect the input module with any monostable switch or switches to control them. One input module can operate up to 6 buttons.
The LMS E2D 6xINPUT MODULE uses only one DALI address regardless of the amount of buttons used.
The device is equipped with a built-in buzzer for identification.
Short-circuiting the input(s) and COM gives a signal/command for testing purposes.
When using the input module in a project, you need to remember the typical Ethernet2DALI limitations.