Versions Compared

Old Version 30

changes.mady.by.user Joanna Kozakiewicz

Saved on

compared with

New Version Current

changes.mady.by.user Kamil Spytkowski

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Make sure that you've completed the previous step: How to get into Vertex GUI?

Note

Pay attention to the type of software. /wiki/spaces/ME/pages/19405210643 have different software versions. The numbering of the Vertex 2 software version starts with the number 2 (e.g. 2.10.1) and for the Vertex 3, it starts with 3 (e.g. 3.1.8).

You cannot update e.g. software version 2.10.1 to 3.1.8.

Info

When updating the Vertex 2 software, the whole Vertex cluster is updated.

When updating the Vertex 3 software, you have to update each Vertex controller in the cluster individually.Downgrading system is not recommended. Uploading the older firmware packages might cause failures such as:

  • Losing configuration data

  • Changing logic of operation (NodeRED flows)

  • Bricking the application controller

Instructions

In the Vertex GUI:

  1. Go to the Settings [1] section.

    Image RemovedImage Added

  2. Log in as an administrator. The default credentials are:
    login: admin
    password: admin1234

  3. Check the software version in the Vertex cluster tab . Compare it with and compare to the current version of the softwarehere Vertex release notes.

  4. Download the software file if neededversion you need.

  5. Go to the Software [2] tab.

...

6. You will see the SWUpdate software screen. Upload the downloaded software filewith the Software Update.

...

7. Wait until everything is uploaded. Don’t worry if the upload will be stuck at 3 or 4%. It process temporarly pauses. This happens because the file that needs to be is being processed is large. Later the upload will speed up.

8. After the upload is finished, you will see information about restarting a notification that the system is restarting. Wait until the whole page is reloaded - for (about 30 seconds).

9. After a while, the The system will then restart for the 2nd time.Don’t Do not exit the page until it’s finished.

10. Go to the Vertex GUI and refresh it by pressing ctrl+F5 or refreshing the pageif you’re on a mobile device.Check if you have the current uploaded version of the software. You will see the information about new release notes.

Info

Here, we used default credentials to log in as administrator. We advise you to change the password for safety reasonssecurity.

Info

After this step, time synchronization is recommended.

↪ The next step: Clearing devices on the buses