Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 12 Next »

If you can’t see any controllers in the netconfig, it may be because of several factors. Read this troubleshooting article and find your solution.

Before you start

Try the proposed solutions in The most common errors. Look for netconfig does not detect one or more VERTEX control units.

If you have both Vertex 2 and Vertex 3 on your site, read /wiki/spaces/ME/pages/1979646009 first.

Solution

  1. Type in the http://YOUR_VERTEX_IP/netconfig in the browser. In the entry screen, check if the IPv4 option is enabled.

  2. Follow the steps described here. Check if all controllers are seen within the netconfig.

  3. Make sure that all controllers are assigned with the intended IP addresses. Then, commission the system accordingly to E2D Commissioning.

If you have done the network configuration before and then you don’t see Vertexes in the netconfig, check if Vertexes have been properly assigned with network settings. Type the http://YOUR_VERTEX_IP:1880/vertex/neghbours in the browser. If the file is empty or unavailable to reach, contact us to get further support.

  • No labels