...
...
...
...
...
This article is for advanced users who has some experience with Vertex controller or E2Dali system and it is a supplementation for Setting up the network article.
Vertex Cluster is a system which allows sending information between devices connected to controller(s) and you are able to create big lighting management system.
To manage your cluster you should enter netconfig Let’s talk a little about the structure of the E2D system.
As you should know, the basic unit is a Vertex. When you start commissioning, we recommend connecting it to a LAN network. When you connect more Vertexes to your LAN network, they will join your first Vertex in a Cluster.
So, a Vertex Cluster is a system made out of up to 25 Vertexes connected to one LAN network. Different Clusters will have different names, which we call Cluster UID or CUID. So, all Vertexes in one Cluster will have the same CUID. Of course, there are many different types of buildings, so choose to commission Vertexes that will likely work together or be in the same area to be in the same Cluster. You do not need to fill each Cluster; they might have a lot fewer devices than 25. Try to use common sense when joining them into Clusters.
In the settings tab you can see your Clusters' topology in or see information about each Vertex.
...
A Vertex group consists of one or more Vertexes inside one cluster. They communicate with each other with peer-to-peer (server/client) communication. A Vertex controller in a group ‘sees’ (knows only of the existence of) other Vertexes in the same group. Communication between groups is still possible but may be slower. You can create up to 15 groups. Using groups is an optimization of communication, where you can separate and limit communication between floors, areas, etc.
How to manage a cluster?
To manage your cluster enter NetConfig: http://VERTEX_IP/netconfig/home
...
After that, you will see all units which you want to configure as groups.
| Info |
|---|
Vertex group in netconfig |
...
is NOT the same as vertex group in GUI/Node-RED. |
...
Vertex |
...
group in netconfig is a group of Vertex controllers. Vertex group in GUI/Node-RED is a group of luminaires. |
...
The last step od netconfig is sending new the configuration to Vertexes with CUID (Cluster UID). We can choose sending . Choose to send the configuration with the old CUID or generate new (default). .
| Info |
|---|
It is important when you are replacing one Vertex |
...
. CUID identifies your site. By selecting the old CUID you don't |
...
have to authorise it again (you don’t lose access and connection to Glamox Connect). |
...
For a better understanding we can consider all options as examples. We can have, consider these two examples:
Vertex controllers in one Vertex group in one cluster in one network
Vertex controllers in different Vertex groupgroups in one cluster in one network
Usually, one LAN network = one Cluster UID and we do not recommend to make more Cluster UIDs in one network.
Hardware explanation of clusters
You can see below structure diagram of vertex communication in cluster. Prosody XMPP server due to routing table is able to trasmit and receive commands or messages to other prosody XMPP server by ethernet connection.
...
For more information go to: