Make If you are in the process of an initial setup make sure that you've completed the previous step: Vertex software updating.
| Note |
|---|
...
By clearing the devices on the |
...
buses you will ensure that all the devices are properly read and addressed |
...
. It’s important you know it’s a hard reset of all devices. |
Instructions
...
Choose Setting section [1]
Go to Vertex cluster [2] and log into the Vertex GUI as an administrator.
Go to the Settings section and then go to the Vertex cluster tab.
Click the Actions Click on the Actions [3]drop down list and choose
Choose the DALI bus you’d like to reset. [4]
...
| Info |
|---|
Clearing devices may take |
...
about 30 seconds. After this operation, the Vertex controller finds the devices connected to the DALI port again and assigns new addresses to them. This may take several minutes. |
↪ The next step:
...