Make If you are in the process of an initial setup make sure that you've completed the previous step: Vertex software updating.
| Note |
|---|
...
By clearing the devices on the |
...
buses you will ensure that all the devices are properly read and addressed |
...
. It’s important you know it’s a hard reset of all devices. |
Instructions
...
Choose Setting section [1]
Go to Vertex cluster [2] and log into the Vertex as an administrator
...
4. Select Clear devices action from the panel below. Then select Run and confirm your selection in the prompt window.
...
.
...
Go to the Devices/Groups section and then select Settings.
...
Select the Vertex/Port tab and choose ports on which you want to clear devices.
Click on the Actions [3]drop down list
Choose the DALI bus you’d like to reset. [4]
...
| Info |
|---|
Clearing devices may take a while, usually about 30 seconds. After this operation, the Vertex controller finds again and addresses the devices connected to the DALI port again and assigns new addresses to them. This may take several minutes. |
↪ The next step:
...