Here are some tips and best practises to make the integration of your local installation and setup of Glamox Connect as easy as possible.
In general, the golden rule is that you should always commision and set up the local installation before connecting to Glamox Connect.
Glamox Connect has automatic discovery, meaning that once you have adopted a gateway from local system into Connect, Connect will discover the devices and add them.
If you then move, remove or replace devices after this you might end up with faults in Connect.
A device in Glamox Connect is a representation of a uniqe device in local installation. Local addressing (like DALI short addresses) are only a location reference.
So replacing Device A with Device B after being added to Connect, will result in Device A being missing and Device B being a new device, regardless if they are on same physical location or same address (like DALI short address)
Ethernet2DALI
Finish cluster and network settings for entire cluster before adding to connect
No floorplans locally so name devices properly
Names are transferred to Connect
DALI Complete
Note down gw - bus - short when locating
No names in transfer to connect
Wireless Zigbee
Note down end of zigbee mac when locating
No names in transfer to connect