1. Connect the gateways to power and ethernet

   • If DALI gateway, also connect DALI line(s)

2. Connect the access point to 24V power and ethernet

3. Make sure the access point has access to the network where the gateways are connected

   • Only the access point speaks to the Glamox Connect cloud. The access point communicates with all gateways and administer the two-way communication between the gateways and the cloud

4. Check the serial number on front of access point (5 digits)

5. Go to URL http://GlamoxConnectCore<serial>.local, for example http://GlamoxConnectCore30288.local if the serial is 30288

6. Make sure that the IP addresses of the gateways will be consistent, either by IT binding the mac address to an static IP (recommended) or by assigning static IP

   • The Access point WebUI from 5. will list all gateways on the network with current settings as long as multicast is enabled in the network

   • For Wireless Zigbee, log in to the web ui of the gateway to set IP if needed

   • For Ethernet2Dali, use Firestarter app to set up IP addresses of gateways

   • For DALI Complete you need to use an external tool, as the DALI gateway does not provide any WebUI

     • Recommended to use free software like for example Lantronix - Device installer

Network setup

• Multicast (optional, access point to discover gateways)

• DHCP (optional)

• Internet access

Finding a device from the mac address

If your access point can’t find the gateways the main issue is probably that they are not on the same network. If you are sure this is not the case, you can try to connect to the network yourself and search for devices.

Make sure you are connected to the same network as the device. Then open a terminal (for example Command Prompt on Windows). Type in “arp -a” and you will get a list of devices with their IP and mac address (physical address).

Find the IP address (internet address) related to your MAC address

DALI complete gateway

To change the IP on the DALI gateway, use a free tool like Lantronix (https://www.lantronix.com/products/deviceinstaller/). Make sure you are connected to the same network and search for devices.

Choose the gateway you want to change on the left side menu and press “Assign IP”. Follow the instructions to configure the IP settings

The gateway has pullout panels on top and bottom of the front. Here you can find detailed information about the gateway like the mac address.

Wireless Zigbee gateway

The Zigbee gateway has a WebUI for easy setup. This WebUI can be reached from your access points WebUI at http://GlamoxConnectCore<serial>.local

Follow gateway manual to go to admin page, default http://192.168.0.211.
You can change the network settings of the gateway under “Network settings”.

Access point

The access point is a linux computer, in the form of a Kunbus RevPi Core 3+. This is a industry grade Raspberry Pi 3+ compute module, running a customized linux distribution.

The device is set up to receive IP via DHCP. To set up static IP, go to the access point webUI at http://GlamoxConnectCore<serial>.local

There you can set the access point IP, network mask, gateway and name servers

For Glamox technicians to reach the device, it is set up with ZeroTier. This requires UDP 9993 to be open out of the network. If the network is set up with DHCP, it will automatically connect, and the technicians can reach the device. As a fallback, a USB 4G modem can be connected to bypass any firewalls while setting up the system.

Tested 4G modems

• Huawei E3531

Note: USB 4G modems that acts as a network interface, without PIN code, can work. Try on your own machine to verify no drivers are needed, and the dongle acts as a normal network interface (no special software required)