After you have located the simulated devicesAfter you have added the simulated devices 3. Creating Simulated Devices, you need to identify and replace them with real devices.
...
Step by step instructions
Select Locate [1].
Ensure your DONGLE is connected and Bluetooth Symbol is illuminated (see
...
Select Find [2], if you are in the range of devices, the list will populate with up to 9 devices.
| Info |
|---|
It could will be necessary required to move around the site to locate all of the luminaires. |
...
...
Tap on the device and use the Override Off
...
[3] button on the top left of the screen. This will turn the luminaire off for
...
3 seconds to allow you to identify which luminaire it is.
...
Once you know which luminaire it is, tap and hold the device and drop it over the simulated device.
...
A Warning message will appear to advise you about replacing the device, click Yes [4].
...
...
Once you have located all of the luminaires in the Find bar, select
Find again to repeat the process. Devices will continue to be found until they are all on a drawing.
...
If you have emergency luminaires, these should be identified at this stage of the process. This should always be done in accordance with the drawings, with a visual check of the luminaire to make certain it is an emergency luminaire.
When locating luminaires and you find an emergency luminaire, select Configure [5] in the bottom left of the screen and select Emergency [6]on the left hand side. This will apply an 'E' to the selected luminaire for identification.
...
↪ The next step: Creating profiles
...