...
In general, the golden rule is that you should always commision commission and set up the local installation before connecting to Glamox Connect.
...
| Info |
|---|
A device in Glamox Connect is a virtual representation of a phisical physical device in your local installation. Local addressing (like DALI short addresses) are only a location reference. So replacing Device A with Device B after being added to Connect, will result in Device A being missing and Device B being a new device, regardless if they are on same physical location or same address (like DALI short address) |
...
If the local system allows you to name devices, it is recomended recommended to name them in a unique manner.
If the local system doesn’t use named devices note the information that is uique for identifying the device.
...
When identifying devices on DALI Complete it is recommended to note down information systematically as you proceed. We recomend also making drawings of exact locations of devices. Note down the following information for each device in a way that you will understand the physical location when/if you want to name and place devices in Connect:
...
Similar to DALI Complete there is no device naming in Wireless Zigbee. The unique ID used by Connect is the Zigbee mac address (NOTE: The BLE mac address is different).
When commisioningcommissioning, note down the location of the device using the Zigbee mac address. If sticker is still present on the physical device you can use this sticker on a floorplan floor plan drawing or similar to quickly save this information.
...