This article shows how to connect a Kinetic switch when you have a Dongle connected and luminaire are identified.
...
These steps need to be followed in the chronological order, or the commisioning commissioning will fail.
...
1.1. Enter the Luminaires tab [1] and choose to open the configure option. Click on the desired luminaire with CPW2-sen or other WR-G4 device [2] to pair with the Kinetic switch (this will act as the Kinetic Master).
1.2. Click ‘Configuration' [3] and tick the ‘Enable EnOcean’ box (EO) [4]. A virtual Kinetic switch device will appear next to the device on the drawing [5]. The Kinetic Switch ID will be the digits of the luminiare and a zero (on the drawing you will see a shortcut).
...
| Info |
|---|
If you have a problem with stuck Kinetic Switch go to Kinetic switch troubleshooting article. |
2. Establishing Links for Scene Control
To perform these actions go to the Luminaires tab and to the Link option [6].
2.1. Linking virtual Kinetic Switch device and Kinetic Switch Master luminaire to self
Click on the Kinetic Switch Master luminaire [7] and select ‘Link to Self' [8].
...
2.2. Linking virtual Kinetic switch device to Kinetic Master luminaire
Draw a directional presence link from the virtual Kinetic switch [9] to the Kinetic switch Master luminaire [10] .
...
2.3. Linking to other Wireless Radio devices
Draw directional prescence links from the virtual Kinetic switch device [11] to other surrounding devices which need to be controlled by the Kinetic switch.
...
3.1. Enter the ‘Profiles’ tab [12] and from the drop down menu [13] , choose ‘NEW PROFILE’.
3.2. Make sure the Controller type is set to SceneController [14] and in the Advanced mode [15] the Dim Up/Down option is ticked [16].
| Info |
|---|
Dimming down - Long press on a button Dimming up - Long press, release and long press again immediately after releasing |
3.3. Save the changes [17] and remember the profiles number, you will be needing it later.
...
3.4. In the ‘Luminaires’ tab, select the new Virtual Kinetic Switch device [18]. Go to ‘Configure’ [19] and from the ‘Scene Profile’ dropdown menu [20] select the newly created Kinetic switch scene profile.
...
3.5. Enter the ‘Scenes’ tab [21] and select the ‘Kinetic Switch Master’ serial number in the Scene Controller drop down menu [22].
3.6 Apply the linked profiles from the drop down menu [23] and press 'Sync'.
...
3.8 Go back to the ‘Luminaires’ tab and make sure the Kinetic Switch Master Configuration is sync’d.
...
4.1. Click on the virtual Kinetic Switch Luminaire [24].
4.2. Click the ‘Pair’ button [25] to activate commissioning mode.
...
| Info |
|---|
Once the light is paired, wait an additional 10 seconds before pressing a scene switch button. Failure to do so will interrupt the final pairing process and you will have to repeat step 2. |
If you have problems with dimming go to the Kinetic switch troubleshooting article.