Presence
Presence linking allows actication of other lumianires when a sensor in a specific lumainire detects presence. You can create individual or multiple links.
The limit on bidirectional linking on a single device is 36. However, unidirectional links can be created without any limitation.
Create individual links
Select Luminaires [1]and Link [2].
Determine the two fittings to be linked and drag your finger between the two devices.
If you require a bi-directional link, draw a line back the other way.
...
| Info |
|---|
If you draw an individual link line, the luminaire will not Link to Self and it's PIR will not become active. Select Link to Self [3] on the individual luminaire to enable this. |
Create multiple links
Select the group of luminaires you'd like to link by dragging your finger over them.
...
You will be presented with 6 options:
Link All(xx) - This will link all luminaires together so that presence detected on any sensor will turn the other linked fittings on.
Unlink All - This will remove all presence links for the group of devices.
Link From X - This will provide a link from another device. If you select this option you will be prompted to enter the full device serial ID. This is used when you want to link from a device on a different drawing.
Link To X - This will provide a link to another device. If you select this option you will be prompted to enter the full device number. This is used when you want to link to a device on a different drawing.
Link to Self – Link luminaires to themselves so they will operate independently.
Me & 8 (dynamic grouping) - This will allow for smaller groups of fittings to be linked within a large group and is typically used in open areas. The '8' can be changed to a larger number with a long press on the 'Me & 8' button. To implement and alter Me & 8:
Highlight the whole group to be controlled in this way
Long press Me&8
A popup box will prompt you to enter the group size > save
Press the Me&xx button again (this will now display the number you entered)
A diagram will appear on the drawing
Confirm to apply or cancel to change
...
| Info |
|---|
If you tap on a luminaire whilst in the Link tab you will see all current links to that device. |
Ensure all the fittings and links are blue and Synced - using the Sync button [4] in the top left.
If you make changes to links or which links a device has then you must check that all changes have been synced.
Daylight
For details see /wiki/spaces/WR/pages/1904312426.