...
Clear the devices on the bus(es) to be sure they will be properly read and addressed by the Vertex unit.
Instructions
...
Select the Vertex/Port tab and choose the ports on which you want to clear devices.
...
4. Select the Clear devices action from the panel below. Then select Run and confirm your selection in the prompt window.
...
Log into the Vertex GUI as an administrator.
Go to
...
Settings/Vertex cluster
Click the Actions drop down list and choose the DALI bus you’d like to reset.
...
| Info |
|---|
Clearing devices may take a while, usually about 30 seconds. After this operation, the Vertex controller finds the devices connected to the DALI port again and assigns addresses to them. This may take several minutes. |
↪ The next step: Rebooting the Vertex
...