Detect and add the luminaires (lights) to a group by lighting them with a torch. If you don't have a torch, use classic identification by blinking as an alternative.
| Info |
|---|
You have to add lights before adding switches. |
| Info |
|---|
The term “lights” refers to a luminaire with built in wireless sensor or wireless driver. The luminaires should be powered up. Lights that are added in a group are considered claimed devices and therefore, not available for other groups, projects or users anymore. |
| Info |
|---|
The Bluetooth of your smartphone needs to be activated. In case Bluetooth is disabled, Wireless ZigBee app will prompt for activation, which the user needs to confirm. |
Instruction
Select one of the groups.
2. Select “+”.
3. Select LIGHTS.
4. The app starts searching for devices within range of your mobile.
5. After some seconds this screen will appear.
6. Direct the light of a torch to the sensor to add it to the group. The smartphone responds with a sound and a brief vibration. Wait for 2 beeps, after which a luminaire will show up in the Added menu. Wait for another 3 seconds before proceeding to the next luminaire. If the sensor does not respond, try adjusting the torch trigger sensitivity.
| Info |
|---|
Use a torch with a well-defined light cone and point to the sensor from 3 - 5 cm distance only to cause a steep light increase. Typically illuminance of the sensor should increase by ≥5000 lx suddenly. In case a luminaire (not in the scan list) is torched, then a re-scan is required to be done. |
7. In the app, the selected light shows up with its Bluetooth address.