TC-0T3-2800226
It is a digital phase dimmer for controlling decorative lighting such as halogens and/or LED retrofit bulbs. You can connect it with a control panel or a sensor in your DALI installation.
The maximum DALI current consumption of this device is 2 mA. It takes one DALI address on the DALI line. Bulbs with a maximum total power consumption of 300 W can be connected to the phase dimmer.
How to use it in the LMS design?
When using the phase dimmer in a project, you need to remember the typical Ethernet2DALI limitations.
Not all LED bulbs are dimmable. Before use, check the product datasheet.
How to commission it?
Identify the phase dimmer in the Vertex UI.
Go into the Vertex UI.
Go to [2] Device list tab located on the left side of the screen.
The Phase Dimmer instance will be visible in General lighting section [3]. You can group it with other luminaires or create a new group. Read Grouping of luminaires if you don’t know how to do that.
Use the Identification button [4] to locate your device.
If you have several lightbulbs connected to the phase dimmer, you see them as one DALI address in Vertex UI. They are controlled like a single DALI luminaire, so you can’t dim them individually.
Program the phase dimmer in Node-RED
Go to the Node-RED. In the dali2devs common node, select the sensor or the wall panel depending on your project.
If you want to dim the bulbs using a button, go to the Dimming button article.
If you want to have the bulbs controlled using a presence/motion sensor, go to the /wiki/spaces/ME/pages/2089353231 article.
Add Comment