/
Luminaire with pull cord functionality

Luminaire with pull cord functionality

Pull cord function is available for luminaires that have a CPW2-SEN and CSD=Cord Switch Dimmable in the sales text.

To commission a luminaire with pull cord you will need firmware version 6.12.10 or newer.

Step by step instructions

  1. Prepare two profiles:

    • A standard luminaire profile with PIR enabled and Pull Cord ticked.

      image-20251218-080338.png

    • A standard Kinetic Switch profile.

For more information on how to set up profiles go here https://glamox.atlassian.net/wiki/spaces/WR/pages/2354937943

  1. In the Luminaires tab identify the luminaire.

For more information on how to identify go here https://glamox.atlassian.net/wiki/spaces/WR/pages/2355101759

  1. Configure luminaire to prepared profile and enable Kinetic Switch.

    image-20251218-080750.png

  2. Configure Kinetic Switch to prepared profile.

    image-20251218-081337.png

  3. Enter the linking tab and link from Kinetic Switch to luminaire.

    image-20251218-081656.png

For more information on how to link go here https://glamox.atlassian.net/wiki/spaces/WR/pages/2355101759

  1. In the Scenes tab select Kinetic Switch and choose the two way switch.

  2. Configure scenes and Sync.

    image-20251218-081828.png

For more information on how to set Kinetic Switch settings go here https://glamox.atlassian.net/wiki/spaces/WR/pages/3073769473

  1. Now your device should react to pull cord commands.