/
Sensor commissioning

Sensor commissioning

Necessary components

  • PIR sensor in the system

  • Tablet

Component usage

PIR sensor responds to movement. You can easily configure how the light should switch on/off at Profiles → Graph Viev.

Turning on

  • LEDs are set to On Level

  • When movement is not detected for some time (PIR Timeout), it goes to Fade Time.

Fade Time

  • Time of transition between diferent light levels.

Standby mode

  • Standby allows for a lower light level before turning the light completely off.

Step by step instructions

  1. Go to the luminaries tab [1]

  2. Find devices [2]. Drag them into drawing [3]. Wait for synchronization [4]. Go to the profiles tab [5].

     

  3. Go to components checkbox [6] and set configuration as below (for microwave settings, please see Microwave settings).

  4. Now you can configure parameters of control system

 

Related content

Integrated sensors for Wireless Radio
Integrated sensors for Wireless Radio
Read with this
WR-D CPW-SEN
More like this
Out-of-box functionality
Out-of-box functionality
Read with this
6. Creating profiles
6. Creating profiles
More like this
Checking & updating firmware
Checking & updating firmware
Read with this
PIR Repeater
Read with this