Connecting a DONGLE

Necessary components


Switching the DONGLE ON

  1. Press pin in small hole once, red LED illuminates briefly.

  2. Press again, green LED illuminates briefly.

Standby mode

The DONGLE automatically goes into standby mode when turned on if no momvement or activity occurs for 15 minutes.

To wake the DONGLE up, rotate the device 180 degrees. See LED Statuses section for more detail.

Switching the DONGLE OFF

  • Press pin in small hole once, red LED illuminates briefly.

  • Press again, green LED goes out.


Step-by-Step Instructions

  1. To connect a new DONGLE to the tablet select the Bluetooth Icon [1].

image-20240207-130554.png

2. Select Discover [2] and press Connect [3] next to the correct DONGLE to accept the Pairing Code. The Mac address of the DONGLE is on the label on the back of the device. Connection is confirmed by Bluetooth icon changing from Grey to Blue.

image-20240207-130745.png

If it doesn't connect:

  • Check DONGLE is On and Awake (Green LED is On or Flashing).

  • Check Mac address (beside Bluetooth icon on Tablet) matches DONGLE.

  • If Mac address is ‘None’ or different to DONGLE then re-pair as left.


Additional Information

LED Statuses

 

Status

Activity

Green LED

Off

Manually switched off or in standby

2 flashes

Charging at 100 mA

3 flashes

Charging at 500 mA

10 second flash

Fully charged in standby (*)

1 second cycle

Running on internal battery

On

Fully Charged and Active

Red LED

4 second flash

Running on battery but battery getting low.

10 second flash

Asleep and battery getting low (*).

Â