Please be aware that this is a legacy version of the support site. If you have software version 3.1.30 or higher go to MODERN Home

(Classic) System backup - restoring

Owned by Katarzyna Stodolny
Last updated: Oct 20, 2023 by Jakub Cupiał

Backups are available for software version 3.1.22 or later.

Attention: Do not connect DALI buses into Vertex unit until backup uploading procedure is finished!

  1. Go to Settings section in Vertex GUI.

2. Login using your admin password if needed.

3. Make sure that the software version is the same as version of Vertex you are replacing, if it is not then upgrade it using software file (3.1.22 or later).

4. Scroll down to Backups section and upload the backup file.

NOTE! the backup must have the same version as the software version.

5. Wait for the backup uploading - it may take several minutes. After backup uploading, Vertex will be automatically restarted to read new configuration.

6. Use netconfig to set previous IP address.

7. Check if Vertex has restored DALI devices and groups properly.