/
(Classic) Checking a DALI installation

This documentation applies to the E2D system using VERTEX 2 & 3 with CLASSIC UI and software versions up to 3.1.29. If you have VERTEX 3 with software version 3.1.30 or higher, go to Glamox Ethernet2DALI

(Classic) Checking a DALI installation

Using the port buttons, you can check that all luminaires are correctly connected to the VERTEX 3* Application Controller (the feature is available from the 3.1.12 software version). Three port buttons are located on the VERTEX front panel (port 1, port 2 and port 3).

  • First press - Recall Max Level on the port

  • Second press - Recall Min Level on the port

  • Third press - Recall OFF on the port

 

If any luminaire is not responding, check the cabling of that luminaire.

The VERTEX 2 Application Controller does not have the port buttons and this function.

See also The most common electrical errors

 

Related content

(Classic) Connection of DALI devices
(Classic) Connection of DALI devices
Read with this
Good practices before commissioning
Good practices before commissioning
More like this
(Classic) Installation guidelines
(Classic) Installation guidelines
Read with this
(Classic) 5. Rebooting the Vertex
(Classic) 5. Rebooting the Vertex
More like this
(Classic) System architecture
(Classic) System architecture
Read with this
(Classic) 0. Good practices before commissioning
(Classic) 0. Good practices before commissioning
More like this