(WIP) PIR sensor commissioning

Necessary components

• PIR sensor

• https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/650001006/

• Tablet

Component usage

PIR sensor responds to movement. PIR sensor connected to or from LED in LMS Wireless Light Sensor KIT. You can easily configure how the light should switch on/off at Profiles → Graph Viev.

Turning on

• LED are set into On Level

• When movement is not detected for some time (PIR Timeout), it goes into Fade Time.

Fade Time

• Time of Turning off LED.

Standby mode

• After Fade Time it is time for Standby Time. LED is set on Standby Level for some time (Standby Time)

Step by step instructions

1. Go to the luminaries tab.

2. Scan for PIR devices.

3. Drag them into drawing.

4. Wait for synchronization

5. Go to the profiles tab

7. Go to Graph viev and change LED parameters