This article shows how to connect Greenpower switch when you have BLE Dongle connected and luminaire is identified.
Necessary components
NEED TO ADD 4-WAY ENOCEAN BUTTON
NEED TO ADD 2-WAY ENOCEAN BUTTON
Requires a Glamox Wireless Radio luminiare with CPW2-SEN sensor.
Step by step instructions
Choose master luminaire and turn on enocean checkbox
As on the upper screen EnOcean ID will be last three digits and adding a zero.
To have connection with greenpower switch you have to press button in specific way.
Open the greenpower icon and select the scene profile related to our luminaire.
Go to profile tab and make sure that LiteIP is set to SceneController and Driver is set to DALI. If you would like to dim up and down luminaire also remember to check Dim Up/Down box.
Click save changes. Now you can select scene profile like below.
Set up the scenes
Click on the EnOcean icon again and on the upper left corner ID number of controller can bee seen.
go back to scene and select scene controller with the same ID
each scene corresponds to a button . In one scene you can control many luminaire with different profiles.
You can also get into advanced scenes settings. To do that go to the profiles tab and select Advanced
If you come back to the scenes tab again there will be much more settings here
If you check Synchronise Profiles box all setting will be the same for all profiles
Link the luminaires
Go to the link tab and select all luminaires. Then go to the Link From X option and at link form type entire number of greenpower button
Pair greenpower switch
As the last step press Pair button. If pairing is successful the master luminaire should blink three times.
