After you have located the simulated devices, you need to identify and replace them with real devices.
Instructions
Select Locate.
Ensure your DONGLE is connected and Bluetooth Symbol is illuminated (see First connection).
Select Find, if you are in the range of devices, the list will populate with up to 9 devices.
It could be necessary to move around the site to locate all of the luminaires.
4. Tap on the device and use the Override Off Button on the top left of the screen. This will turn the luminaire off for 5 seconds to allow you to identify which luminaire it is.
5. Once you know which luminaire it is, tap and hold the device and drop it over the simulated device.
6. A Warning message will appear to advise you about replacing the device.
7. Once you have located all of the luminaires in the Find bar, select Find again to repeat the process. Devices will continue to be found until they are all on a drawing.
If you have not simulated devices, click and hold the device and drag it onto the drawing and position it manually.
If you drag a luminaire onto the wrong drawing, this can be dragged back off the drawing or into the Find Bar so it can be found again.
If you are too far from one of the found devices:
you can ignore it and Press Find again (the device will be found again on a subsequent Find)
or drop it into the 'Hold Box' - the small white box below the Find Box
Emergency luminaires
If you have emergency luminaires, these should be identified at this stage of the process. This should always be done in accordance with the drawings, with a visual check of the luminaire to make certain it is an emergency luminaire.
When locating luminaires and you find an emergency luminaire, select Configure in the bottom left of the screen and select Emergency on the left hand side. This will apply an 'E' to the selected luminaire for identification.
Add Comment