Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 20 Next »

Wireless ZigBee Button is a button switch which is designed for use in the Glamox Wireless ZigBee system.

No wiring and lack of power connections give wide possibilities of mounting. Installation is easy and the device does not require maintenance.

The device also does not need internal battery or any external power supply. Energy source is an electro-dynamic energy generator inside the switch.

The comfort of the usage is very high due to low mechanical force needed for pressing the buttons.
In addition to conventional ON/OFF control you can use this button for dimming the light and triggering lighting scenes.

Product page on Glamox website

LMS ZIGBEE GREENPOWER 2B

LMS ZIGBEE GREENPOWER 4B

Item requires additional frame: https://www.glamox.com/en/pbs/products/indoor/downlight/1411701/

Device features

  • No battery and no wiring

  • Gluing or screwing onto the flat surface

  • ON/OFF, dimming, scene control (4B only)

Commissioning procedure

For commissioning a switch, follow the steps shown in the app.

Limitations - how to use it in the LMS design

  • Range: within one room (up to 10m line of sight),

  • Add all luminaires in a group first and then add a switch. Switch binding mechanism is to each node within the Zigbee group at the time of commissioning. If new nodes are added after commissioning, switch binding does not take place.

  • A switch can be added either to a group or to a zone. Once added to a zone, another switch will need to follow the same choice i.e. either a group or a zone.

  • Up to 5 switches can be added within a group. All switches attached within a group should belong to a single brand. Combining switches from different brands is not recommended.

  • In case switches are used for a group and at the same time for zones of that group, three things need to be taken into account:

    • The switch of the group should be added first.

    • Only 2-button switches should be used for the group.

    • In the zones 4-button switches with scene setting can be used.

  • It is recommended to use not more than one 4-button switch per zone.

  • If two or more zones are used with a 4-button switch, the maximum number of lights is 20 per zone.

  • In case the switch is not detected during the commissioning procedure, please re-try.

  • The switch needs to be mounted so that “I” is at the TOP and “O” at the BOTTOM (check picture).

  • During commissioning of ZGP switches (in test setups) the devices should not be too close to the lights (between 2m and 5m distance) to avoid commissioning failures.

  • No labels