Release information

Device name	LMS ZIGBEE SENSOR (Product page)
Release date	-

Highlights

Solved problems:

When occupancy sharing is disabled the sensors of a group still do not work standalone: all lights of the group still go to Eco-on level whenoccupancy is detected. Only granular dimming does not occur.
When daylight-based control is enabled, the following limitations apply:
- The calibration routine for daylight regulation takes longer (about 7 minutes) than with higher firmware versions. For luminaires,where the calibration fails due to too little light reflections from dark surfaces (e.g., a dark grey carpet) in the field of view of the
  daylight sensor, the luminaire goes to maximum light output. In contrast to higher firmware versions the light level is not capped at
  the Eco-on level. If this results in luminaires with too high light output, we recommend disabling daylight regulation of these
  luminaires.
- In case daylight control is enabled, a double press of Switch ON action (with wireless switch) is needed for lights to go to Eco on level.The 1st button press brings the lights to Background light level; a subsequent 2nd button press will bring the lights to Eco on level as
  expected.
- Two occupancy triggers are needed for the lights to go to Eco-on level. In case people enter a room the luminaire that triggersoccupancy first goes to background light level only while the other luminaires go to Eco-on when they trigger presence too. Within
  some minutes the light of the first luminaire slowly increases to Eco-on.