...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
Necessary components
(WIP) LMS WIRELESS SCENE CONTROLLER: Office & Industrial
(WIP) LMS WIRELESS SCENE CONTROLLER BATTERY
...
Installation
LMS Wireless Scene Controller:
...
| Info |
|---|
The batteries will last for more than 5 years with up to 50 activations per day. |
...
Step-by-Step Programming Instructions
Creating a Scene Controller profile:
Click 'Profiles' and 'Component' view [1].
Create a Profile for a Scene Controller.
Make sure SceneController type is selected [2].
Make sure the PowerOn level in ‘Driver’ settings is at least 1W.
To enable dimming and and dimming down functionality of the switch, make sure ‘Dim Up/Down’ [3] is ticked in the LiteIP Controller box (Make sure you are on 'Advanced' mode).
Click ‘Save Changes’.
...
Click 'Luminaires' and 'Locate'.
Simulate a Device (by clicking in the empty Find Column [4] under the Find then drag the orange (simulated) device onto the drawing in an appropriate location.
...
Click 'Configure' and change the profile of the device to the Scene Controller profile you have created above [5].
...
Creating links from the Scene Controller to other devices:
Click 'Link'.
Link the Scene Controller to the Devices to be controlled by:
drawing lines one at a time from the scene controller to the luminaire controller [1] OR,
highlight a group of devices to be controlled, then click “Link From X” [2] and enter the FULL serial number of the Scene Controller.
...
Select 'Scenes' from the main menu at the top of the screen.
If this displays a set of buttons only, as below, then close this view by clicking 'Edit' [1] and enter the security pin (0000 by default).
...
Ensure than the tablet is connected to the DONGLE and stand within RF range of the luminaires.
Select a Scene (1-6) and click 'Test' [1].
Repeat for each scene and adjust levels as required.
...
Click ‘Luminaires' and 'Locate’.
If you know the full serial number of the physical device then Change the Serial number from the Simulated 4 digit serial to the real number by Long Clicking the serial number [1] and entering the full 6+ digit number.
Click the simulated device icon on the drawing and it should change from Orange to Blue.
...
Click ‘Scenes'.
All scenes will be red (unsycned), click ‘Sync’ [2] to sync all scene settings with the physical device. All scenes should turn blue once completed.
...