Interface device to translates Android Tablet messages to A Bluetooth Dongle including software licence for communication between the commissioning tablet and the Wireless Radio Protocolsystem.
...
Name
...
Itemcode
...
LMS WIRELESS DONGLE INC SOFTWARE
...
650001003
Product Image
...
Product Features
Used in conjunction with Wireless Radio software and Android tablet.
Kept in your pocket when in use for commissioning or monitoring.
Stored on your desk plugged into USB port for charging when not in use.
Hardware Connections
MicroUSB lead supplied. If replaced always use a sync lead and not a charge only lead.
Charge from Mains, Car or for the most efficient charge, via a PC USB socket.
Preserves battery life when not in use by going into standby mode after 15 minutes of inactivity.
Physically rotate to wake from standby mode.
24 hours continuous use battery life when being used for commissioning.
30 days battery life when in standby mode.
Operation
Charge for 24 hours before undertaking commissioning using the supplied MicroUSB lead.
To turn on, insert a pin into the small hole on the right hand side of the device. Wait for the red light on the front of the device to flash and then tap again.
The top light will now go green and then slowly flash green.
To turn off, insert a pin in the small hole and hold until both lights go off.
Line Drawing
...
650001003
https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/650001003/
Switching the DONGLE ON
Press pin in small hole once, red LED illuminates briefly.
Press again, green LED illuminates briefly.
Standby mode
The DONGLE automatically goes into standby mode when turned on if no momvement or activity occurs for 15 minutes.
To wake the DONGLE up, rotate the device 180 degrees. See LED Statuses section for more detail.
Switching the DONGLE OFF
Press pin in small hole once, red LED illuminates briefly.
Press again, green LED goes out.
LED Statuses
| Status | Activity |
|---|---|---|
Green LED | Off | Manually switched off or in standby |
2 flashes | Charging at 100 mA | |
3 flashes | Charging at 500 mA | |
10 second flash | Fully charged in standby (*) | |
1 second cycle | Running on internal battery | |
On | Fully Charged and Active | |
Red LED | 4 second flash | Running on battery but battery getting low. |
10 second flash | Asleep and battery getting low (*). |
How to use the device with the commissioning app?
https://glamox.atlassian.net/wiki/spaces/WR/pages/3004071937/Copy+of+4.+Connecting+a+DONGLE