Versions Compared

Old Version 5

changes.mady.by.user Eric Younger

Saved on

compared with

New Version Current

changes.mady.by.user Nils Ove Erstad

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

First, select the access point you want to connect the gateways to. Then you can proceed to click Adopt next to the gateway(s) you want to adopt, or click Adopt gateway manually

When you are done adding gateways to the access point, press Reload configuration in the next step. Not pressing reload will cause the gateways to be displayed as faults.

Discover devices

The last step you need to do is to discover devices. Glamox Connect will then create devices in Connect for all your local devices.

Info

Please note that commissioning of the local systems should be done prior to starting this process. If not properly commissioned, Glamox Connect will not be able to discover your devices (i.e. no short address, not connected to gateway ++)

It is also highly recommended to make notes during commissioning of the local system, i.e. on the location of each device. This will save you a lot of time commissioning in Glamox Connect when placing luminaires on floorplan.

Image Modified


Just choose which system you want to discover devices from, select gateway (and lines if applicable and desired) and press Run. Connect will then request list of devices and listen for changes from your local installation. The progress and number of devices will be listed.

When you are done adding devices, press Reload configuration in the next step