...
...
...
...
...
...
...
...
...
...
...
...
Necessary components
PIR sensor
https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/650001006/
in the system
Tablet
Component usage
PIR sensor responds to movement. PIR sensor connected to or from LED in LMS Wireless Light Sensor KIT. You can easily configure how the light should switch on/off at Profiles → Graph Viev.
Turning on
LED LEDs are set into to On Level
When movement is not detected for some time (PIR Timeout), it goes into to Fade Time.
Fade Time
Time of Turning off LEDtransition between diferent light levels.
Standby mode
After Fade Time it is time for Standby Time. LED is set on Standby Level for some time (Standby Time)Standby allows for a lower light level before turning the light completely off.
Step by step instructions
Go to the luminaries tab [1]
Scan for PIR Find devices [2]. Drag them into drawing [3]. Wait for synchronization . [4]. Go to the profiles tab [5].
Go to components checkbox [6] and set configuration as below (for microwave settings, please see (WIP) Microwave settings).
Connect https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/650001006/ with sensor as on upper schematic.Now you can configure parameters of control system
...