Versions Compared

Old Version 9

changes.mady.by.user Nils Ove Erstad

Saved on

compared with

New Version 10

changes.mady.by.user Nils Ove Erstad

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Note

NOTE: Setting of IP on gateways is not yet possible to do on site, without special software. If your system engineer does not have this software and training, the IP’s need to be set up before the gateways are installed

  1. Connect the gateways to power and ethernet

    • If DALI gateway, also connect DALI line(s)

  2. Connect the access point to 24V power and ethernet

  3. Make sure the access point has access to the network where the gateways are connected

    • Only the access point speaks to the Glamox Connect cloud. The access point communicates with all gateways and administer the two-way communication between the gateways and the cloud

  4. If needed, change the IP’s of the gateways to preferred IP address (See note!)

  5. If Glamox Wireless Zigbee the gateway needs to be set up with an access code to connect access point to the gateway

    1. Follow gateway manual to go to admin page, usually 10deafult http://192.168.0.28.190211

    2. Make sure to be on same local network to reach the gateway

    3. Go to Security tab and activate “Access code”

    4. Use access code 1337 (default for the gateway integration) or the access code part of the QR code on back of gateway.

    5. Press “Activate” to allow for new connections for 5 minutes. The gateway integration needs to start within these 5 minutes. If successful you will see the access point connected to the gateway.

  6. The IP’s and access code are given to the Glamox Connect installer

    1. NOTE: In the future this will be available in the admin interface for the customer

Finding a device from the mac address

...

Follow gateway manual to go to admin page, usually 10default http://192.168.0.28.190211.
You can change the network settings of the gateway under “Network settings”.

...