...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
...
Step by step instructions
Make sure you have the latest commission app software.
| Info |
|---|
You can check it on the Google Play Store. However, you must be logged into your Google account. |
...
Make sure the
...
Glamox Wireless Radio device you wish to update has been found and placed on the Site ID drawing. The Device Type will also need to be noted.
...
Make sure your DONGLE is connected to the App
...
. Click on the Bluetooth icon [1] and check if the DONGLE has firmware version 3.140 (or higher) [2]
...
...
Click the Luminairestab [3] and select the Site ID [4].
...
Click on Firmware [5].
...
Find and select the Device Type you want to update in the top left dialog box [
...
6]. Devices that are on drawings on this site will be marked blue, other devices are marked grey.
Find and select Load [
...
7] on the correct firmware version you wish to use located in the bottom left dialog box.
...
The screen will turn grey for 10 seconds to load the firmware file, please wait for this to finish.
| Info |
|---|
If you are unable to see Library files in the bottom left dialog box, click the Refresh button and wait 15 seconds. Then click on the Device Type in the top left dialog box again and firmware files will have now downloaded. |
...
The Firmware file will now be loaded into the DONGLE (this can be seen in the bottom right dialog box) [8].
...
11. Click on the desired Device Type you wish to create a rule for within the Device Types dialog box.
...
12. Select the Vmin value in the table and enter the Firmware version you require and click Save (in this example we will be using a Device Type 25 and Firmware version 5.040).
...
13. Select the Vmax (this will now be shown as v9.999) value in the table and enter the Firmware version you require and click Save.
...
Now you will be selecting target rules for the device you are updating. We recomend for the Version Min [9] and Version Maximum [10] should be set to the same version you are currently updating to.
Now close the firmware page.
10. Once you have created your firmware rules, click Close
...
on the
...
Software Update page.
...
11. Click on the Luminairestab.
...
You will now see a RED Firmware value over the
...
device which you have set an
...
update [11]. Now long click on the firmware version of device until [12] a pop up box appears asking if you wish to automatically update devices, click yes [13].
12. Stand close to the
...
Glamox Wireless Radio device you wish to update, click on the RED button with firmware version of the device [14] and update will
...
begin.
...
The screen will turn grey for roughly
...
a few minutes to update the devices Firmware. Please do not turn the screen off or press any other buttons at this time.
| Info |
|---|
If the update fails, move the DONGLE closer to the device and retry this step |
...
. |
| Info |
|---|
If you are using an LMS Wireless Scene Controller Battery, then you will need to wake the device up before updating it. To do this, perform one of two actions, either:
OR
|
13. To verify the update has been completed, select the device again and
...
click on the top left corner of the commissioning app to refresh and identify the new Firmware version [
...
15].
...
