Why might this be necessary?
...
Ensure the new drawing is imported and ready to use.
Go to the drawing where you wish to move the devices from.
Select the devices you wish to Cut and Paste by entering the Luminaires tab[1], Locate section [2] and highlighting the group of devices [3].
Long press ‘Delete xx Devices' [4], this will change to Paste. As soon as you long press ‘Delete xx Devices', the devices will disappear from the drawing.
...
Click on the drawing to paste, amke sure to do this in a top left corner, to fit all devices.
...
| Note |
|---|
If you tap in an area where the fittings will not all fit on the drawing i.e. bottom right then several devices will be missing from the drawing.  |
...