Microwave settings are used when there is a Microwave sensor in the Wireless Radio system. It can be an integrated sensor like the CMW-sen. In this article we will show you how to set and adjust a Microwave sensor to work properly in a set environment.
...
First create a microwave profile. In the components section make sure that the Light IP component is set to Microwave [1] and the driver is set to what you have in your lumianires [2]. Now go to the Advancced settings [3].
...
Click on the Microwave [4]. You will then see three consecutive fields where you will set parameters of micorwave settings you need. The settings will be later visable in he advanced setting as Microwave dimming/Triggers/Sensitivity. Remember to save changes!
...
You can make a small tweek to the sensitivity parameter of an individual luminaire by clicking Microwave Tweek [5] in the Configure section. This will allow you to change the setting anywhere from -5 to lower sensitivity to +5 to increase sensetivity of a lumainire.
| Info |
|---|
If you change a profiles' settings tweeks in your systems will not be affected. |
...