...
...
...
...
...
...
...
...
...
...
...
...
Necessary components
Component usage
PIR sensor responds to movement. PIR sensor connected to or from LED in LMS Wireless Light Sensor KIT. You can easily configure how the light should switch on/off at Profiles → Graph Viev.
Turning on
LED are set into On Level
When movement is not detected for some time (PIR Timeout), it goes into Fade Time.
Fade Time
Time of Turning off LED.
Standby mode
After Fade Time it is time for Standby Time. LED is set on Standby Level for some time (Standby Time)
Step by step instructions
Go to the luminaries tab [1]
Scan for PIR devices [2]
Drag them into drawing [3]
Wait for synchronization. [4]
Go to the profiles tab [5]
Go to components checkbox [6] and set configuration as below.
Connect https://www.glamox.com/en/pbs/products/light-control/wireless-solutions/650001006/ with sensor as on upper schematic.
Now you can configure parameters of control system
Done 😊